Page Comparison

...

1. Check that your protocol allows for "Duplicate Enrollment". 

   1. Even if a subject was only consented and then screenfailed, OnCore will consider adding the patient again as a duplicate enrollment. 

   2. Go to PC Console > Management Tab

   3. If your study does not allow duplicate enrollment, talk to your supervisor or regulatory coordinator to modify this setting.
      

   4. If your study is set to Yes, Follow the workflow for new subject registration

      1. When you attempt to add this subject again, you will receive a pop-up notification to verify you want to add an existing patient again

      2. You will Click Continue and complete a new registration

      3. Enter a consent for the subject.

      4. Enter the new eligibility status and continue the typical workflow for the subject.

*Institutional required fields marked in red, bold font