Page Comparison

Step-2 Enter the collection date for the fluid specimen; plasma. You can do this by simply clicking the checkbox against it. System will put the collection date and time as current date and time which can be changed, if needed. Also, if the collected quantity is less than the default Quantity shown, then change the quantity to the correct total quntity quantity value at this step. In the example shown here, only 2 tubes totalling 4ml is collected. Therefore, the quantity is changed to 4ml from the default value of 6ml.

Step:3 Next click the form icon against the plasma specimen which will open the Specimen form. You may enter any comments at the top but this is not mandatory. However, Specimen Barcodes are Mandatory and must be entered as shown below. In the following example, CRA was able to collect only 2 out of 3 required tubes and entered the Tube barcodes as shown. CRA must enter N/A against the third tube as it is Mandatory. In this case, user collected only 2 tubes totalling 4ml and therefore the Quantity must be entered as 4.0 instead of the default value of 6ml.

Step 4: Upon clicking save, Specimen status changes to Collected as shown below.